RMS-2AS AM Monitor station
The RMS-2AS AM Monitor station is a complete system solution, designed to remotely monitor the input and output signals of AM transmitters, as well as demodulate the RF input to monitor and provide an audio output for quality verification, with additional back-chassis terminal connections to monitor and control other devices & site perimeter at the transmission site. Additionally, the RMS-2FS incorporates an embedded event-scheduler allowing remote scheduling of the controlled output for remote test & verification purpose at the site. The RMS-2AS comes with an integrated Ethernet/IP port. Alarms are typically sent as SNMP traps over Ethernet-IP Networks to designated Monitor & Control Centers. Additionally, alarms can be programmed to activate some of the back-chassis controlled contact outputs, to connect with and sent alarms to an existing Monitor & Controle system at the remote site where the RMS station is installed. In addition to SNMP protocol for remote monitor/alarm & control, an embedded Web-server is available for remote monitoring and control from a Web-page which can be opened from any Web-Browser over the Network with access restriction. The Web-page incorporates a setup menu that gives the operator remote access to the RMS station for channel selection and change of default RF level Threshold alarm settings. The RMS-AS can also be used as a demodulator in emergency situations. The demodulated audio output however, available from the rear panel, is typically used for audio quality monitoring. Additional rear panel terminals are available to alarm and/or monitor/control via contact closure other equipment & perimeter at the transmission site. The RMS-AS is frequency agile. It can be tuned to any channel in the AM/MW Band. The desired frequency is set remotely from the Web-page by computer over the Network.
Tekron Communication is dedicated to work with Cable Television and Broadcast system operators to provide new solutions to their changing needs